|
|
|
|
Now
you can form the last bend on transverse duct! Or form up flanges on either side of a tab by removing apron fingers.
Assorted
apron fingers
plus moveable blocks on the table allow you to create two or more
down flange openings anywhere you need them. The last bend on
transverse duct is now easy to form. Why wait at the end of the line when
you can do it now? Built
to last AND to be rebuildable in the real world: clamp cams, vertical guide
assembly, clamp finger sets, entire clamp, apron bushings, apron fingers, and
the apron leaf are replaceable, and reasonably priced.
. IMPORTANT
feature: Each clamp finger is individually adjustable for leading edge
alignment, helping you avoid "the dimples" over time, and greatly
increasing the useful life of the finger set. Replacement fingers, individually
or in sets, are readily available and affordable.
.
Two extra clamping fingers are included: one SPECIAL 4" FINGER
to bend up to 3/16" mild steel w/o adjusting beam set back or
clamping pressure, plus one spare stock 4" finger.
.Bolt
on radius bars are optional, including 1/16 through 1/2 radius
(1/2" r = 1" dia.), OR, add radius to the leading
edge of the clamp fingers in a wide range of radii. For larger radii see our
Radius Brake..
Stock clamp finger widths are 2, 3 & 4. OR, you may specify any
assortment or width up to the full width of the brake. Ask about the low cost of
additional fingers or full sets. How about a few 8 fingers, or 24, or a
one piece finger the full width of the brake?
Stock apron finger widths are 2, 3, 3 ½, 4, 6, 12
& 35 ½. This assortment of apron fingers along with the moveable table
blocks allow you to create a down flange opening any where you need it.
4, 5, 6, 8 & 10 models. All are 1 over length
Maximum depth of box using clamp fingers: 4 1/2 inches
16ga, 14ga, or 12ga mild steel capacity on 1 1/2 flange with apron
angle installed Minimum reverse
bend: 1/2 (or may be ordered with optional 1/4 return)
Beam set back adjustment: 1 (additional set back is optional and
will be needed for bolt on radius bars over 1 diameter)
Lift of beam*: 2 1/4 at leading edge of fingers
Six (6)* adjustable rods or plates for center alignment. *Exceptions: # U4-4816 & U4-4814: lift of beam 1 1/4; one counter
weight; 4 adjustable truss'
Stop rod for repeat bends is included All
these models are floor mount except 4 16ga (legs optional) Three year
material and workmanship warranty. Transportation is the buyers expense. Down Flange apron and table is also available on straight (non-finger) brakes
|
|
Details [ Prices ] [ Options ] Straight Brakes [ S Series ] [ L Series ] Finger Brakes [ BP Series ] [ U Series ] [ C Series ] Brake Options [ TD Option ] [ Hydraulic Assist Option ] [ Radius Brake ] [ Bead Roller ] Copyright © 2001
ProFormer, LLC
|
